ATON DLA2 User Manual download pdf

LIMITED WARRANTY

ATON* warrants to the purchaser/end user (“you”) that the DLA2RKT/DLA4RKT/DLA6RKT is to be free from defects in materials and workmanship for a period of one (1) year from date of purchase (the “Warranty

Period”). This warranty is transferable to subsequent owners of the product as long as the original proof of purchase is retained. If you discover a defect in material or workmanship within the Warranty Period, you

can obtain warranty service by contacting ATON during the Warranty Period at (859)-422-7137 or ser[email protected]. If ATON determines that the product is in fact defective, ATON shall, at its option, repair or

replace the product free of charge to you.

This warranty shall not apply to equipment (a) not manufactured by ATON, (b) to equipment which was improperly installed, (c) which was repaired or altered by persons other than ATON or its authorized repre-

sentatives or subject to unauthorized tampering, alteration or modification, (d) damaged due to misuse, negligence, accident, acts of God (including, but not limited to, excess moisture, insects, lightning, flood,

electrical surge, tornado, earthquake, or other catastrophic events beyond ATON’s control), or (e) subject to improper operation, maintenance or storage or unreasonable use. The foregoing warranties do not cover

reimbursement for labor, transportation, removal, installation or other expenses which may be incurred in connection with repair or replacement. The foregoing remedies shall be your exclusive remedies for any

breach of warranty.

Further, the foregoing warranty does not extend to equipment sold, but not manufactured by, ATON (“Third Party Products”). With respect to any Third Party Products, the warranty for such product shall be as pro-

vided by the manufacturer of such product, who will also be responsible for warranty service, and ATON will pass through to you any transferable warranty actually extended to ATON by the manufacturer.

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESSED AND IMPLIED WARRANTIES. ATON EXPRESSLY DISCLAIMS ALL SUCH OTHER WARRANTIES, INCLUDING BUT NOT LIMITED TO

IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-INFRINGEMENT. Notwithstanding the above, where applicable, if you qualify as a “consumer” under the Magnuson-

Moss Warranty Act, then you may be entitled to any implied warranties allowed by law for the Warranty Period. Some states do not allow limitations on how long an implied Limited Warranty lasts, so the above

limitation may not apply to you.

ATTENTION: TO OUR VALUED CONSUMERS

Valid proof of purchase is required for all warranty services. Warranty service requests made without proof of date of purchase will be denied. Please keep the original sales receipt for your records and send a

copy to request warranty service.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

* ATON is a division of ELAN Home Systems, LLC.

ROOM 1

ROOM 1 ROOM 1

ROOM 2

ROOM 2 ROOM 2

ROOM 3ROOM 3 ROOM 4 ROOM 4

ROOM 5 ROOM 6

ALL

OFF

ALL

OFF

ALL

OFF

SCENE SCENE SCENE

MUTE MUTE MUTE

VOL

Place included

Room labels here

ATON

PORT

PATENT

PENDING

PWR IN

12VDC / 2.1A

AMPLIFIER

INPUT

IR EMITTER

OUTPUTS

Receiver

DLA2RF

Rear View

Mounting

Holes

RJ-11

Plug

Mounting

Bracket

Tabs

Mounting

Bracket

Button Function

Room 1-6 Selects Rooms for Adjustment

All On Turns All Rooms On

All Off Turns All Rooms Off

Scene Places Rooms into Scene Preset Mode

Mute (Toggle) Press to Reduce Volume of Selected Room to 0, Press

Again to Increase Volume to Previous Level

Vol + Increases Volume of Selected Room by One Step

Vol - Decreases Volume of Selected Room by One Step

DLA 2 / 4 / 6 Room

RF Remote

w/ Receiver

Mount RF Receiver at the DLA selector equipment location

using included mounting bracket. Secure mounting bracket

using (2) phillips screws (included) and slide RF Receiever

mounting holes onto the mounting tabs of the bracket.

Note: ATON recommends mounting RF receiver as high as

possible for best reception.

Connect RF Receiver RJ-11 plug into ATON Port.

Plug power supply into DLA Selector and then into wall

AC power outlet.

Test remote by selecting a room and then ramping Volume Up

and Down, Muting, etc.

RF Remotes

Make sure RF receiver is plugged into the DLA ATON Port

and that the DLA Selector is powered On (power supply is plugged in).

Remove the access cover from the bottom of the RF receiver.

Press and release the Program button - Program LED will turn solid.

Within 10 seconds press and release the “Scene” button on the

additional remote you wish to program into the receiver.

If the remote is programmed into the receiver correctly, the program

LED will immediately turn off.

Repeat steps 3-5 for additional remotes (up to seven remotes can be

programmed into one receiver).

NOTE: Only ONE RF receiver can be used per DLA Selector. Program all ad-

ditional remotes into the original RF receiver. The remote that is included

with the original RF receiver is pre-programmed to the receiver and will

function without additional programming.

For Installations Requiring Multiple RF Remotes

JP1

JP2

JP3

JP4

JP1

JP2

JP3

JP4

Access Cover

RF Receiver

Program Button

Program LED

For Installations Using Only One RF Remote

P/N DLARKTIS REV:A

2 Room

4 Room 6 Room

www.atonhome.com

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in

a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be deter-

mined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

Caution: Any changes or modiﬁ cations not expressly approved by ATON could void the user’s authority to

operate this equipment.

1 2 3

Summary of Contents

Page 1 - RF Remote

LIMITED WARRANTYATON* warrants to the purchaser/end user (“you”) that the DLA2RKT/DLA4RKT/DLA6RKT is to be free from defects in materials and workmans

Page 2 - Control Remoto RF

ROOM 1ROOM 1 ROOM 1ROOM 2ROOM 2 ROOM 2ROOM 3ROOM 3 ROOM 4 ROOM 4ROOM 5 ROOM 6ALL ONALL ONALL ONALLOFFALLOFFALLOFFSCENE SCENE SCENEMUTE MUTE MUTEVOL+VO

Page 3 - Spanish on reverse side

INSTR, INSTL, DLA2/4/6 RF REMOTE KITLINEAR P/N DLARKTIS REV:AINK: BLACKMATERIAL: 60 LB WHITE COATED PAPERSCALE: 1-1SIZE: 8.500 X 14.000, TOL: +/- .040

ATON DLA2 User Manual

Browse online or download User Manual for Soundbar speakers ATON DLA2. RF Reference SheetcombinedPLAY.indd

Summary of Contents

More documents for Soundbar speakers ATON DLA2

Comments to this Manuals